全國服務熱線
13503801616
新聞資訊
News
振動電機激振力如何調整
IV, adjust the vibration force
The vibration force is setting to its maximal value at default state. If the shock force is too large, the user can remove both ends of the shield, loosen the outer ends of the eccentric (adjustable eccentric) locking bolts, synchronous adjust the angle between the adjustable and fixed eccentric, so that vibration force to meet the requirements, and tighten the locking bolts. When adjusting the eccentric, the bigger the angle, the smaller the
振動電機出廠時,激振力處于大位置,若激振力過大,用戶可將兩端防護罩拆下,松開兩端外偏心塊(可調偏心塊)鎖緊的螺栓,同步調節兩端可調偏心塊和固定偏心塊之間的夾角,使激振力達到要求,并在此緊固鎖緊螺栓。調節偏心塊時,夾角越大,激振力越小,注意每次調節時,必須使電動機兩端的偏心塊夾角大小相等,且偏向振動電動機同側。
警示!激振力的調整應保證振動電動機兩邊偏心塊數量一致調整角度相同,即兩邊偏心塊應調整在相同的設定值位置,否則激振力不均勻,影響振動電動機壽命或損壞。
經過幾個小時初期運轉,檢查振動電動機電流,進一步檢查緊固件,鎖緊螺栓。
警示!觀察振動電動機工作電流不得超過標牌標示值。如果振動電動機連續工作超過標示值,可能引起電動機損壞。還有必須按照振動電動機標示頻率運行否則會引起振動電動機損壞。vibration force. Note that for every adjustment, you have to make sure, that the angle of the eccentric block on both ends of the motor must be equal, and tend to the same side of the motor.
返回頂部